Fig. 2-96
Fig. 2-99
AN410D
NOTE: To ensure the cleanliness of the flywheel magnets, place the flywheel (with the magnets facing upward) on a clean bench.
AR106
Fig. 2-100
4. On the 500 cc/600 cc, remove the four Allen-head cap screws securing the magneto case to the crankcase. Fig. 2-97
AN414D
NOTE: The stator plate screws had Loctite applied to the threads during assembly. Using an impact driver, apply a sharp blow to the head of each screw to break the Loctite loose before removal.
AN412D
5. On the 500 cc/600 cc, remove the Allen-head cap screws securing the stator to the stator plate.
7. On the 580 cc, remove the Allen-head screws securing the stator base. On the 500 cc/600 cc, remove the ignition timing sensor. Fig. 2-101
Fig. 2-98
AR107
AN413D
6. Remove the Allen-head cap screws securing the stator plate. Remove the stator plate from the engine.
2-24