Fig. 2-233
Fig. 2-236
725-318A
A770
Fig. 2-237
21. Using a piston holder to “square� the piston, compress the piston rings and install the cylinder. Do not force the cylinder. If cylinder binds, remove, check the position of the piston rings, and install. Fig. 2-234
A773
25. Place the ignition coil into position; then secure with two screws and lock washers. Connect the coil lead to the lead from the magneto. A771
Fig. 2-238
22. Place the head gasket into position. Fig. 2-235
A757
A772
23. Place the cylinder head into position. The head must be positioned so the cooling air flow is parallel to the fin pattern. 24. Tighten cylinder head nuts to 0.8-1.2 kg-m (6-9 ft-lb) using the pattern shown.
2-56
26. When installing the stator plate, align the scribed marks made during disassembly. Apply red Loctite #271 to the three screws; then tighten the screws securely.