)LJ
)LJ
$
$
)LJ
21. Using a piston holder to “square� the piston, compress the piston rings and install the cylinder. Do not force the cylinder. If cylinder binds, remove, check the position of the piston rings, and install. )LJ
$
25. Place the ignition coil into position; then secure with two screws and lock washers. Connect the coil lead to the lead from the magneto. $
)LJ
22. Place the head gasket into position. )LJ
$
$
23. Place the cylinder head into position. The head must be positioned so the cooling air flow is parallel to the fin pattern. 24. Tighten cylinder head nuts to 0.8-1.2 kg-m (6-9 ft-lb) using the pattern shown.
26. When installing the stator plate, align the scribed marks made during disassembly. Apply red Loctite #271 to the three screws; then tighten the screws securely.