GZD15, WSM
GENERAL
Changing Transmission and Rear Axle Gear Case (RH and LH) Fluid
A Be sure to stop the engine before changing the transmission fluid 1. Place an oil pan underneath the transmission case. 2. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely. Remove the clamp and hose (2) from L shape adaptor (3) at the rear axle gear case (RH & LH) bottom and drain rear axle gear case (RH & LH) fluid. 3. After draining, disassembling and clean the strainer and change the oil filter cartridge. After reassembling, fill with UDT or SUPER UDT hydraulic transmission fluid, or its equivalent. 4. Remove the filler plug (5) of the both rear axle gear cases. Fill with the new oil up to the plug port. After filling, reinstall the filler plug. 5. Remove the oil plug and breather cup (6), and fill with the new oil. 6. After running the engine for a few minutes, stop it and check the oil level again; add oil to the prescribed level. A Use only multi-grade transmission oil. Use of other oils may damage the transmission or hydraulic system. Refer to "LUBRICANTS, FUEL AND COOLANT" (See page G-7.) A Operate only at low RPM's immediately after changing the transmission fluid and filter cartridge. Keep the engine at medium speed for a few minutes to insure proper lubrication of all parts so there is no damage to transmission. A Never work the machine immediately after changing the transmission oil. Keeping the engine at medium speed for a few minutes prevents damage to the transmission. A Do not mix different brands oil together. Transmission case and rear axle gear case (RH and LH) fluid
(1)
Drain Plug
(2)
Hose
(3)
10.0 L 2.6 U.S.qts. 2.2 Imp.qts.
L Shape Adaptor
0000001429E
G-21
KiSC issued 04, 2006 A