Section 3
Routine Maintenance Transmission
8-1
Checking the Slew Gearbox Oil Level 1
Section 3 8-1
JS130W/JS145W
Prepare the Machine Position the machine on level ground. Stop the engine and remove the starter key.
2
Locate the Slew Gearbox Refer to Component Location Diagrams at the end of this section.
3
4
C
Check the Level a
Remove the dipstick A, wipe it clean and re-fit.
b
Remove the dipstick again and check that the oil level is within the range B.
c
If necessary, top up through filler port C. Refer to Lubricants and Capacities for oil type.
B D
Re-fit the Dipstick.
Changing the Slew Gearbox Oil 1
A
A
JS160W/JS175W
Prepare the Machine Position the machine on level ground. Stop the engine and remove the starter key.
2
3
Drain the Oil a
Remove the drain plug D. Allow the oil to drain out.
b
Wipe the drain plug clean. Remove any metallic particles.
c
Refit the drain plug. Make sure it is tight.
C
A
A
B
Fill with New Oil Refer to Lubricants and Capacities for oil type and volume.
D
Fill with new oil through filler port C until it reaches the full mark on the dipstick when settled. Refit the dipstick. 4
Check for Leaks Run the machine, operate the slew controls and make sure there are no leaks.
9803/6310
Issue 2*