INSP ADJ
CONTROL SYSTEM
E 2. Adjust: • Remote control throttle cable length Adjustment steps (1) Loosen the locknut 1. (2) Remove the clip 2. (3) Disconnect the cable joint at the magneto control lever 3. (4) Close the throttle grip fully. (5) Turn the magneto control lever so that the full retard adjusting screw 4 contacts the crankcase. (6) Adjust the position of the throttle cable joint until its hole aligns with the set pin. (7) Install the clip and tighten the locknut.
CAUTION: The remote control cable joint must be screwed in more than 8 mm (0.31 in).
3122
ADJUSTING THE START-IN-GEAR PROTECTION (E115AMH, E115AWH) 3
b
1. Inspect: • Start-in-gear protection operation Incorrect → Adjust. 2. Adjust: • Start-in-gear protection wire adjuster position
a
3126
Adjustment steps (1) Set the shift lever in the neutral position. (2) Loosen the bolt 1. (3) Adjust the start-in-gear protection wire adjuster 2 so that the point a on the wire connector aligns with the mark b on the flywheel cover. (4) Tighten the bolt. 3127
3-13