2
New 1000 Series
Data and dimensions Note: This information is given as a guide for personnel engaged on engine overhauls. The dimensions which are shown are those which are mainly used in the factory. The information applies to all engines, unless an engine type code is shown.
Cylinder head Angle of valve seat: - Inlet .. ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... 46° (88° included angle) or 31° (118° included angle) - Exhaust ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... 46° (88° included angle) or 31° (118° included angle) Leak test pressure . ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... 200 kPa (29 lbf/in2) 2,04 kgf/cm2 Head thickness .. ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... 102,79/103,59 mm (4.047/4.078 in) Finish grade of head face for cylinder head joint ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... 1,10/3,20 micrometers Diameter of parent bore for valve guide: - Inlet .. ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..13,00/13,027 mm (0.5118/0.5128 in) - Exhaust ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..14,00/14,027 mm (0.5512/0.5522 in) Minimum permissible thickness after head face has been machined ... ... ... ... ... ... ... ..102,48 mm (4.035 in) Maximum permissible distortion of cylinder head Four cylinder engines A1... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,08 mm (0.003 in) A2... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,15 mm (0.006 in) A3... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,15 mm (0.006 in) Six cylinder engines A1... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,13 mm (0.005 in) A2... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,25 mm (0.010 in) A3... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..0,25 mm (0.010 in)
1
1
1
1
1
1
1
3 2
3 2
A 12
A0067
Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale