Model
1. 9. 1992
21. Engine
Code
6000-- 8750
1. 1. 1994
211
Page
2
0,1 ---0,4 mm
3. Press in a new bushing. Note the position of the oil hole. It is unnecessary to ream the bushing because it has a correct inner diameter when it is fitted in place. Note! On the 620 and 634 engines from the engine ser. number C2751, all camshaft bearing points are provided with a separate bearing bushing. Observe the different outer diameters when removing and fitting.
5
4
3
Order numbers of the camshaft bushings and hole diameters for the bushings on the 620/634 engines. Note! Numbering begins from the front end of the engine.
2
1
Order no
Hole diameter
1. 8363 22610 2. 8368 52460 3. 8368 52459 4. 8368 52460 5. 8368 52461
55,62...55,65 55,40...55,43 55,20...55,23 55,40...55,43 55,62...55,65
140 mm
134 mm
6---7 mm
E. Oversize bushings for camshaft If the location of the camshaft bushing (front bearing) is damaged, a bushing with a 0,4 mm oversize outer diameter can be fitted. Bushings are available even for other camshaft bearings which do not normally have bushings. Part numbers and machining dimensions for the bushing locations are shown in the figure.
4
3
2
1
Oversize camshaft bushings for 320 ---engines. Numbering begins from the front end of the engine.
Observe the position of the bushing oil holes. It is unnecessary to ream the bushings after fitting.
44
Order no
Hole diameter
1. 8363 24661 2. 8368 52460 3. 8368 52460 4. 8368 52461
56,02...56,05 55,42...55,45 55,42...55,45 55,64...55,67