15
SECTION 2001 STEP 18
STEP 16
Using the smaller of the measurements obtained in STEP 16 and STEP 17, refer to the table below to determine the correct number of shims to be installed between the engine sump and front bolster.
DP98B140
To determine the correct number of shims to be installed between the engine sump and front bolster, measure and make a note of the gap between the LH side of the sump and front bolster using feeler gauges. The gap must be measured at two places (above and below the bottom mounting bolt hole).
STEP 17 Repeat STEP 16 for the RH side of the engine sump.
Measured Gap
Number of Shims
0 to 0.25 mm (0 to 0.0098 inch)
0
0.26 to 0.5 mm (0.010 to 0.0196 inch)
1
0.51 to 0.75 mm (0.020 to 0.0295 inch)
2
0.76 to 1.00 mm (0.0299 to 0.0394 inch)
3
1.01 to 1.25 mm (0.0397 to 0.0492 inch)
4
1.26 to 1.28 mm (0.0496 to 0.050 inch)
5
IMPORTANT: The measured gap must not be more than 1.29 mm (0.0507 inch). If the gap is greater than 1.29 mm (0.0507 inch) use suitable lifting equipment and remove the front bolster. Clean the mounting faces and check for burrs or damage. Repeat STEP 15 to STEP 18. NOTE: The shim pack thicknesses may be different for both sides of the engine sump.
SM 8-10661
Issued 06-2002