ENGINE LUBRICATION SYSTEM
Put 10 qts. (9,5 L) of oil in the engine.
Replacing Oil And Filter (Cont’d)
Start the engine and let it run for several minutes. Stop the engine. Check for leaks and check the oil level. Add oil as needed if it is not at the top mark on the dipstick.
Figure 10-110-3
1
P-31297
WARNING Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-1285
Remove the oil filter (Item 1) [Figure 10-110-3]. Clean the filter housing surface. Put clean oil on the new oil filter gasket. Install the filter and hand tighten only. Install and tighten the drain plug. Figure 10-110-4
2
P-31258
Remove the filler cap (Item 2) [Figure 10-110-4]. 10-110-2
S250 Bobcat Loader Service Manual