HYDRAULIC/HYDROSTATIC SYSTEM
A
Checking And Adding Fluid Use only recommended fluid in the hydraulic system See SPECIFICATIONS, Page 9–1 for the correct fluid. To check the reservoir, use the following procedure: Put the Bobcat loader on a level surface. Lower the lift arms and tilt the Bob–Tach fully back. Stop the engine. Remove the dipstick [A].
CD–15162
The fluid level must be between the marks on the dipstick.
B
If fluid is needed, remove the fill cap (Item 1) [B]. NOTE: Before installing the fill cap, make sure the rubber gasket is installed on the fill cap (Inset [B].
CD–15135
1
CD–15161
Add the fluid as needed to bring the level to the top mark on the dipstick [A].
C 1
Replacing Hydraulic/Hydrostatic Filters See the SERVICE SCHEDULE, Page 1–3 for the correct service interval. Raise the operator cab. (See Page 1–8.) Use a filter wrench and remove the filter elements (Item 1 & 2) [C].
1
Clean the surface of the filter housing where the element seal contacts the housing. Put clean oil on the rubber seal of the filter element. CD–10855
Install and hand tighten the filter elements.
–1–21–
853, 853H Loader Service Manual