INSTRUCTIONS Cable must have a free play of about 2 mm (3/32”) before unlatching lid. If latch doesn't work properly, upper cover must be removed and cable readjusted. If cable is too loose, more cable sheath must be past extrusion groove. If cable is too tight, less cable sheath must be past extrusion groove. When cable is properly adjusted, Torque upper cover to extrusion bolts in a criss cross pattern at a torque of 25 N•m (18 lbf•ft).
Warning Label This product comes with a warning label containing important safety information. The label should be considered permanent part of the product. If the label comes off or becomes hard to read, please contact an authorized BRP dealer for free of charge replacement. Any person who intends to use this product should read and understand the information contained on the warning label before doing so.
rsi2008-010-250
(P/N 704 901 871)
Location of the Warning Label
rsi2008-010-105_a
Apply Loctite† 243 thread locker (P/N 293 800 600) on lower cover bolts [P1.2] and fasten lower cover [P1.1] to upper cover [P1]. Torque bolts to 10 N•m (95 lbf•in). Reinstall and reconnect battery.
WARNING
Always connect RED (+) cable first then BLACK (-) cable. Reconnect turn signal connectors. CAUTION: Always test light operation after reconnecting turn signal connectors.
rsi2008-010-300
Under lid.
Reinstall rear panels by fastening screws securing front part and reinstalling reusable plastic rivets. Reinstall upper side panels. Reinstall bottom tail cover.
† Loctite is a registered trademark of Loctite Corp.
6/6
Instruction Sheet P/N 487 800 252