STEERING SYSTEM/LUBRICATION
INSP ADJ
3. Adjust: • Ski toe-out
È
LT
Adjustment steps: • Loosen the locknuts (tie-rods) 1. • Turn the tie rods 2 in or out until the specified toe-out is obtained. • Tighten the locknuts (tie-rods) 1.
LT
1
2
2
1 T.
R.
É
Tie-rod end locknut: 25 Nm (2.5 m · kg, 18 ft · lb) LOCTITE®
CAUTION:
LT
After tightening the inside and outside ball joint locknuts 1, make sure the tie rods 2 can be rotated freely through the ball joint travel. If not, loosen the locknuts 1 and reposition the ball joint so that the tie rods 2 can be rotated freely. Tighten the locknuts to specification.
LT
2
1
2
È Outside É Inside
LUBRICATION Brake lever, throttle lever and throttle cable end 1. Lubricate the brake lever pivot, throttle lever and the ends of the throttle cables. Recommended lubricant: ESSO Beacon 325 Grease or Aeroshell Grease #7A
WARNING Apply a dab of grease onto only the end of the cables. Do not grease the throttle cables. They could freeze and cause a loss of control.
2-41