Replacing Hydraulic Fluid And Case Drain Filters
Pull the reservoir drain hose (Item 1) [Figure 10-120-5] out the motor cover hole. Remove the plug and drain the fluid into a container.
Figure 10-120-5
Figure 10-120-6
HYDRAULIC/HYDROSTATIC SYSTEM (CONT'D)
1
1
P-31286
P-34905
(See SERVICE SCHEDULE on Page 10-70-1.), for the service interval.
Disconnect the hoses from the hydrostatic motor case drain filter (Item 1) [Figure 10-120-6].
Replace the fluid if it becomes contaminated or after major repair.
Remove the case drain filter and clean thoroughly with clean solvent.
Also clean the hydrostatic motor case drain filter thoroughly after a major repair.
Install the case drain filter and tighten the hoses.
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Install the plug in the reservoir drain hose and tighten. Install the motor cover.
Remove the left hydrostatic motor cover.
10-120-3
T300 Bobcat Loader Service Manual