FINAL DRIVE TRANSMISSION (CHAINCASE)
Removing And Replacing Oil
Checking And Adding Oil
Remove the check plug (Item 1) [Figure 10-130-1] from the front of the chaincase housing.
The chaincase contains the final drive sprockets and chains. Use the same type of oil as the hydraulic/ hydrostatic system. (See HYDRAULIC/HYDROSTATIC FLUID SPECIFICATIONS on Page SPEC-40-1.)
Figure 10-130-2
Stop the loader on a level surface. Stop the engine. Figure 10-130-1
P-31287B
1
Use a pump to remove the oil from the chaincase [Figure 10-130-2]. Recycle or dispose of the used oil in an environmentally safe manner. N-18438
Remove the plug (Item 1) [Figure 10-130-1] from the front of the chaincase housing. If oil can be reached with the tip of the your finger through the hole, the oil level is correct. If the level is low, add oil through the check plug hole until the oil flows from the hole. Install and tighten the plug.
10-130-1
S205 Service Manual