FINAL DRIVE TRANSMISSION (CHAINCASE)
Removing And Replacing Oil
Checking And Adding Oil
Figure 10-130-2
The chaincase contains the final drive sprockets and chains. Use the same type of oil as the hydraulic/ hydrostatic system. (See HYDRAULIC/HYDROSTATIC FLUID SPECIFICATIONS on Page SPEC-40-1.)
1
Stop the loader on a level surface and stop the engine. Figure 10-130-1
1 P-76684
Remove the check plug (Item 1) [Figure 10-130-2] from the front of the chaincase housing. Figure PM-3
P-31287
Remove the plug (Item 1) [Figure 10-130-1] from the front of the chaincase housing. If oil can be reached with the tip of the your finger through the hole, the oil level is correct. If the level is low, add oil through the check plug hole until the oil flows from the hole. P-31287A
Install and tighten the plug.
Use a pump to remove the oil from the chaincase [Figure PM-3]. Recycle or dispose of the used oil in an environmentally safe manner.
WARNING AVOID INJURY OR DEATH Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire. W-2103-0508
10-130-1
S205 Service Manual