3
4
1243
Attachment No.2
TEST VALUE AND TEST LIMIT (GST ONLY — NOT APPLICABLE TO CONSULT-II) The following is the information specified in Mode 6 of SAE J1979. The test value is a parameter used to determine whether a system/circuit diagnostic test is “OK” or “NG” while being monitored by the ECM during self-diagnosis. The test limit is a reference value which is specified as the maximum or minimum value and is compared with the test value being monitored. Items for which these data (test value and test limit) are displayed are the same as SRT code items. These data (test value and test limit) are specified by Test ID (TID) and Component ID (CID) and can be displayed on the GST screen.
SRT item
Self-diagnostic test item
DTC
CATALYST
Three way catalyst function EVAP control system (Small leak) EVAP control system purge flow monitoring
P0420 P0440 P1447 P0130 P0130 P0130 P0130 P0130 P0136 P0136 P0136 P0136 P0135 P0135 P0141 P0141 P0400 P0400 P0400 P0400 P0400 P0402 P0402
EVAP SYSTEM
Heated oxygen sensor 1 HO2S
Heated oxygen sensor 2
Heated oxygen sensor 1 heater HO2S HTR Heated oxygen sensor 2 heater
EGR function EGR SYSTEM
EGRC-BPT valve function
Test value (GST display) TID CID 01H 05H 06H 09H 0AH 0BH 0CH 0DH 19H 1AH 1BH 1CH 29H 2AH 2DH 2EH 31H 32H 33H 34H 35H 36H 37H
01H 03H 83H 04H 84H 04H 04H 04H 86H 86H 06H 06H 08H 88H 0AH 8AH 8CH 8CH 8CH 8CH 0CH 0CH 8CH
Test limit
Conversion
Max. Max. Min. Max. Min. Max. Max. Max. Min. Min. Max. Max. Max. Min. Max. Min. Min. Min. Min. Min. Max. Max. Min.
1/128mm2 20mV 10ms 10mV 10mV 10mV 1s 10mV/500ms 10mV 10mV 10mV 20mV 20mV 20mV 20mV 1 1 1 1 1 1count 1count
1/128
5
6
7
8
9
Thank you very much for your reading. Please Click Here. Then Get COMPLETE MANUAL. NO WAITING
NOTE: If there is no response to click on the link above, please download the PDF document first and then click on it.
10
11