DIB17_0618_Quick Start Guide for USB Link

QUICK START GUIDE FOR WIDEX USB LINK

DIB17/0618

www.widexPRO.com

INSTALLING AND USING THE WIDEX USB LINK The Widex USB Link makes it possible to fit Widex wireless hearing aids on CompassTM GPS and Compass V5.7.2 software without the use of cables connected to the hearing aids.

Prior to connecting the USB Link to your computer, you must install the driver. The driver software is located in the Support folder on the Compass GPS memory stick, at www.widexPRO.com, or on the Compass V5 CD. 1. Browse to the Support folder and open it.

2. Open the Widex USB Link driver folder, then open the Version 1.x.x folder.

3. Double click the setup.exe file to install the driver. Follow the on-screen prompts.

4. When the installation has completed, click Finish.

5. Now plug the Widex USB Link into the computer.

6. Open Compass GPS or Compass V5 software and setup the interface section for the USB Link:

ompass GPS: Select Compass Setup from the left hand column C of the Session Start section and then select Interface. ompass V5: Select Setup from the top tool bar and then select C Interface.

9. If the USB Link is on the list of Available interfaces on the left, click it to highlight it, then click Add to move it to the right side under Current interfaces.

10. Click the USB Link again to highlight it, then click the Test/Connect button located a bit lower on the screen.

11. You should get a message telling you that the connection to the USB Link has been established. Click OK and you are ready to use the USB Link.

Please note: If this is the first time you are installing Compass GPS, the USB Link driver can be installed during the installation process by selecting Install the USB Link drive (recommended) box and following the prompts.