Link Product / Engine

Drive shaft Front axle system

Front bevel gear set and dif ferential

Final drive hub, steering knuckles, and shafts

Axle suspension control

Rear axle system

Rear bevel gear set and dif ferential Planetary and final drives

Rear axle track yoke assembly

Steering control Hydraulic control components Pump

Foreword - Important notice regarding equipment servicing

All repair and maintenance work listed this manual must carried out only qualified dealership strictly complying with the instructions and whenever the special

Anyone who performs repair and maintenance operations without complying with the procedures provided herein shall responsible for any subsequent

The manufacturer and all the organizations its distribution chain, including - without limitationnational, regional, local reject any responsibility for damages caused parts and / components not approved the facturer , including those used for the servicing repair the product manufactured marketed the manufacturer any case, warranty given attributed the product manufactured marketed the manufacturer case damages caused parts and / components not approved the manufacturer case refer your NEW HOLLAND Sales and Service

The manufacturer reserves the right make improvements design and changes specifications any time without notice and without incurring any obligation install them units previously and illustrative material herein are accurate known time publication but are subject change without notice.

Introduction

Safety rules

Personal safety

This the safety alert used alert you potential personal injury Obey all safety messages that follow this symbol avoid possible death injury

Throughout this manual you will find the signal words W and CAUTION followed special These precautions are intended for the personal safety you and those working with

Read and understand all the safety messages this manual before you operate service the

DANGER indicates a hazardous situation not will result death serious injury

W

ARNING indicates a hazardous situation not could result death serious injury

CAUTION indicates a hazardous situation not could result minor moderate injury

F AILURE T O FOLLOW DANGER, W ARNING, AND CAUTION MESSAGES COULD RESUL T DEA SERIOUS INJUR Y .

Machine safety

NOTICE: Notice indicates a situation that, not avoided, could result machine property damage.

Throughout this manual you will find the signal word Notice followed special instructions prevent machine property damage. The word Notice used address practices not related personal safety .

Information

NOTE: Note indicates additional information that clarifies other information this

Throughout this manual you will find the word Note followed additional information about a step, other information the The word Note not intended address personal safety property

Safety rules - General maintenance safety

General maintenance safety

Keep the area used for servicing the machine clean and dry Clean spilled

Service the machine a level

Install guards and shields after you service the machine. Close all access doors and install all panels after servicing the not attempt clean, lubricate, clear obstructions, make adjustments the machine while motion while the engine

Always make sure that working area clear tools, parts, other persons and pets before you start operating the Unsupported hydraulic cylinders can lose pressure and drop the equipment, causing a crushing hazard. not leave equipment a raised position while parked during unless the equipment securely

Jack lift the machine only jack lift points indicated this manual.

Incorrect towing procedures can cause When you tow a disabled machine follow the procedure this Use only rigid tow

Stop the remove the key , and relieve pressure before you connect disconnect fluid

Stop the engine and remove the key before you connect disconnect electrical connections.

Scalding can result from incorrect removal coolant Cooling systems operate under Hot coolant can spray out you remove a cap while the system hot. Allow the system cool before you remove the cap. When you remove the turn slowly allow pressure escape before you completely remove the

Replace damaged worn electrical

The exhaust and hydraulic lines may become hot during T ake care when you service such Allow surfaces cool before you handle disconnect hot W ear protective equipment when

When follow the instructions the Always disconnect the battery before you weld the Always wash your hands after you handle battery