Rev 2:1
199E
Powder Coated Finish
PEUGEOT BIPPER, FIAT FIORINO & QUBO CITROEN NEMO & MULTISPACE MAY 2008 e11*94/20*7794*00
Components Code
Quantity
Description
CB
1
Crossbar
LS
1
RS
1
Bolt Kit Code
Quantity
WA
4
10mm Large Round Washers
Left Side Plate
C
2
16x50 Bolts, Nuts & Grip Washers
Right Side Plate
B
4
12x35 Bolts, Nuts & Grip Washers
A
4
10x110 Bolts, Nuts & Grip Washers
BU
4
76x16 Bushes
w1088
Description
1. Lower and remove spare wheel 2. Using side plates as a guide, drill the chassis rails, for improved access remove the spare wheel pully mechanism from the underside of the boot floor. 3. Hold up each side plate to the inside face of each chassis rail ensuring that each plate is up to the rear of each chassis and to the top of each chassis. Mark off and drill the four points through the chassis rail 11mm. Open up the outer holes 18mm. On the wheel arch lining, cut away a small section to allow a 30mm washers to pass through to the chassis. 4. Loosely attach side plates LS and RS to the chassis rails using bolts A with bushes BU and washers WA. 5. Loosely attach crossbar CB to side plates LS and RS using bolts B. 6. Attach towball a50/1 (not supplied) using bolts C. Replace spare wheel pulley together with spare wheel. 7. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com