IRON WORKER Turn the machine to the jog mode and test the machine Take out the punch and die, clean them, and put them back on the shelf Clean the die holder and put the new die in Make sure the punch is clean and put in the machine Jog the punch down to check that the punch is in the center of the die (if it isn’t in the center, DO NOT let the punch touch the die; make adjustments as needed) Set the two stops for the proper size plates you will be making Set the limit switches for the stroke on the punch (this will be up and down) Turn the machine to manual and run a test plate; let a QC inspect part
PLEASE FOLLOW ALL SAFETY PROCESSES NAD PROCEDURES WHEN OPERATING THIS MACHINE
Controlled By: Quality Assurance Dept.
Revision Date: 9/5/2025