Header HEADER Set SET Up UP Lock-out and tag machine Move bar stop our of the way Take the die tooling out of the machine Put in the new die tooling and tighten set screw Take our the gripper blocks and replace them with the new gripper block; make sure to put the shims back on each side of the gripper blocks Set the bar stop to proper length Take off your lock and turn the machine off Jog machine one cycle Turn machine off wait for machine to come to a complete stop, then make sure to tighten the lock down bolts on the gripper blocks Turn the induction unit (heater) on Run a test bar Make adjustments as needed until the part meets specs
PLEASE FOLLOW ALL SAFETY PROCESSES NAD PROCEDURES WHEN OPERATING THIS MACHINE
Controlled By: Quality Assurance Dept.
Revision Date: 9/5/2025