Glue pads + glue Rev 3 Eng

Glue Pads + Glue Installation guidelines

©2025 All rights reserved

Eng

Please read these instructions carefully before starting installation. Failure to follow these instructions may result in damage to the product or property.

Installation should be carried out by qualified personnel only. If you are not confident with any part of the installation process, please contact a professional installer for assistance.

The manufacturer is not responsible for any damage caused by incorrect installation or misuse of the product.

Please check all parts and tools are included before installation.

Ensure the parts and tools are suitable for the product’s weight and size.

Ensure the mounting surface is suitable for the product’s weight and size.

Always use appropriate safety equipment and take necessary precautions when working with tools and electricity.

These instructions are provided as a guide only. Actual installation may vary depending on specific circumstances and site conditions.

Required Tools • • • • •

Cleaning Solution Masking Tape Bubble Level Pressure Roller (Optional) Clean Cloth

E-mail: support@signage-group.com Phone: +49 (0)30 863280590 Opening hours: Mon. - Fri., 9:00 - 17:00 Uhr Office address:Bogen 45, Holzmarktstr. 15-18 10179 Berlin Germany

2

Step 1

Step 2

Step 3

Before using any cleaning solution on wall surfaces, it is recommended to test it in an inconspicuous area to ensure the solution does not cause discoloration, damage, or other adverse reactions. Prepare the surface by cleaning it from dust and degreasing it. Make sure the surface is smooth and even.

Attach the mounting template to the wall. Use a bubble level to align it properly.

Secure the template to the wall using masking tape.

Step 4

Step 5

Step 6

Turn the letters face down. Remove the protective film from the glue pads.

Apply glue to the back of the letters in areas where there are no glue pads.

Attach the letter in the correct spot following the mounting template and press it firmly against the wall using your hand or a pressure roller.

3

Step 7

Step 8

Step 9

Repeat the process for the remaining letters.

Leave letters over night in template allowing the glue to fully cure.

Next day carefully remove the mounting template, making sure not to pull off any letters.

Once glue fully cured, remove the protective film from the front of the letters if present.

4