Instruction Manual Form 5159 June 1981
EWN and EW-1 Series
EWN Series and EW-1 Series Valve Bodies Introduction Scope of Manual This instruction manual includes installation, maintenance, and parts information for 8 x 6-inch, 12 x 8-inch EWN Series and EW-1 Series valve bodies (figure 1). Refer to separate manuals for instructions covering the actuator and accessories.
Description These single-port globe-style valves have cage guiding, threaded seat rings, metal-to-metal seating, and push-down-to-close valve plug action. Additional details are given in tables 1 and 2.
Specifications Typical specifications for these bodies are shown in table 1. Some of the specifications for a given body assembly as it was shipped from the factory appear on the actuator nameplate if the body is part of a complete control valve assembly.
Installation W3310/IL
Personal injury or equipment damage caused by sudden release of pressure may result if the valve assembly is installed where service conditions could exceed the limits given in table 1 or on the appropriate nameplates. To avoid such injury or damage, provide a suitable overpressure protection device as required by local, state, and Federal codes and good engineering practices.
Figure 1. 12 x 8-Inch Design EWNT-2 Valve Body with Type 470-16 Actuator
D100400X012
WARNING