Introduction to Span Tables

Introduction to Span Tables www.designpine.com.au

Skip

Continue

Screen layout • The layout remains the same for all applications • Application list on the left • Inputs required and outputs appear on the left • Engineers certifications are bottom left

Application Inputs • All applications need a basic set of inputs which the software requires to calculate the maximum span for each product listed.

• A diagram and ‘?’ are there to assist you to define inputs.

Search for Results • Once the inputs are defined click search, the results from the search will appear on the left.

• The results will list all products which exceed the desired span.

• Locate the desired product, select ‘add to report’ to save this information.

Reports • Added products are listed

• Application • Size • Strength rating for the member • Parameters entered • Max span or result

• Remove products

• If a product if not correct simply remove and replace with and alternate

Reports • Functions on the report • Print Report • Continue editing

• Add more applications / products to the report

• Reset report

• Removes all products saved to the report

• The report may only contain results will the same wind zone and roof load, this is shown in the parameters on the report.

Handrails • They are presented differently from the other applications. • All products and spans are tabled with a small profile drawing.

Certification • All data is certified by two independent engineers • Certificates should satisfy council requirements