6. Prepare the pleated blind. Remove rubber band. Unroll cord (with tension cord bracket on top) and remove the tension cord brackets on the bottom from the adaptor.
8. Mount handles. Slide both handles sideways onto the adapter.
7. Mount
The unit is operated by moving the profiles on the operating handle. Note: When the profile and the tension cord bracket engage, you will hear a click.
handle
9. After having checked that the pleated blind functions as prescribed, the excess cord ends can be cut off.
Attention: Adjustment of the cord tension must be uniform and may only be made by a professional.
Care
Thanks to a special manufacturing process, our fabric qualities are furnished with an antistatic finish and are therefore resistant to dust and dirt.
Occasional brushing with a soft brush or a feather duster is usually sufficient.
When cleaning glass and the window frame, make sure that no water or caustic cleaning agents come into contact with the pleated blind fabric.
No guarantee can be offered for damage to fabrics that is attributable to condensate, cleaning agents or soiling by insects. For further care information, refer to the cleaning instructions.
Model P1615 with adhesive profile
Dear Customer,
this dimensionally accurate pleated blind was produced especially according to your requirements. High qualilty materials and a design that is perfect in function and elegance guarantee a long service lifetime and thus ensure great pleasure in the purchased product.
Your pleated blind Manufacturer
Please read this intructions carefully before fitting the blind Blinds must be fitted by skilled personnel. Wrong installation may result in accidents. Alterations of the blind must be approved by the blind manufacturer.
1 x cleaning cloth
Mounting
Adhesive tape: tesa® ACXplus 7055
For additional cleaning instructions or handling (e.g. disassembly) see: http://www.tesa.com/industry/tesa_acxplus
https://www.benthin.com/en/blinds/pleated-blinds/
Mounting
Mounting Content
2. Prepare adhesive profiles
Connect adhesive profiles and adapter.
Note: The outline of the adaptor is the same as that of the adhesive profile.
Adapter adhesive profile contour
4. Remove protective films from the adhesive profiles
Slowly pull off the protective films of the adhesive profiles
Attention: Do not touch the adhesive surfaces!
5. Fix adhesive profiles to the window pane
Place adhesive profile first on the front edge of the glazing bead (A) and then push it parallel to the glazing bead towards the glass pane. Press adhesive profile firmly to the fixing substrate (B)!
Note: This contact pressure is essential for establishing the best possible adhesive bond, and it prevents the formation of air bubbles.
3. Adjust adhesive profiles
Position the adhesive profiles on the window (A) and, if necessary, adjust the adaptor of the glazing bead: Loosen the screws (B), align the adaptor with the glazing bead angle (C) and fasten the screws again (D).
Attention: The adhesive profile will immediately adhere to the surface. Therefore, it cannot be repositioned and the adhesive strip cannot be reused!
Front edge of the glazing bead
Adhesive strength: At a room temperature of 21°C, the adhesive strength will reach 50% of its final strength after 20 minutes. 75% after 1 hour, 90% after 24 hours and 100% after 72 hours.
The surface of the glass has to be clean and dry! (free of grease, oil, dirt and silicone)