Guide to Install Shutters With Blind Shade and Shutter Company in Cape Coral!

To determine the size of shutters you require, measure the height and width of your window.

Use a filler strip to support the front edge of your window frame, level it, and then mark the screw holes with a pencil After that, use a 1" filler strip to pre-drill the holes They also serve as an excellent layout template.

Procedure

3. Quantify the blinds

Measure the total width while assembling the shutters

4.

Glue the filler strips in place

Decide how many filler strips you’ll need, or you ask a professional blind shade and shutter company In Cape Coral. After that, insert screws into the shutter frame, and all the filler strips should slide onto those screws.

5. Install the blinds

Maintaining the shutters on one side of the window while lining up the screws with the previously drilled holes. Once the screws are in place, gradually tighten them On the opposite side of the window, repeat this process. Making the screws excessively tight is one thing you should avoid if you need to make modifications.

6. Verify and correct the alignment

To ensure they are all properly aligned, close the shutters. The cover plugs for the screw that typically come with the kit should be inserted once you have made the appropriate modifications and the shutters can close correctly

Procedure

perfectshadecompany com

7. Mark the location of the hardware

Make a pencil mark just halfway down the face of your shutter doors It is to organize the shutter hardware. After that, set a particular level on the mark. On both sides of the shutter frame, make an effort to draw a straight horizontal line with a pencil

8. Gauge and drill the holes beforehand

Create a vertical line that intersects with the horizontal line after taking measurements to determine the centers of each door frame. On each shutter door, drill holes in advance where the horizontal and vertical lines converge.

9. Fix the fixtures, then test

To secure your shutters, close the latch To ensure that you completed the installation correctly, you should also test it.