Recommended Work ng Pressure 150-500kpa
1.ScrewtheMixerBodyontoNoggin
2.EnsuretheMixerBodyislevel
3.ConnectHotandColdWaterSupply
4.TestandCheckforLeaks
INSTALLATION INSTRUCTIONS
WALL MIXER
USING FOR:
Note:
1. If the pressure exceeds or l ke y to exceeds 550kpa, an approved pressure limit ng device must be installed
2. F ush Out al pipe work prior to installation
3. If the water temperature exceeds 75℃, an approved tempering valve must be fitted.
4. Instal ation should comply withAustralian StandardAS3500
Failure to comply with the above may void a l warranties
1.ThecentreDistanceofthemixerbodyis120mm.
2.Creattwosuitableholesinthecement sheetandtiles
3 Finishthetiles,tomaintainthelengthat11mmto13mm (fromthetiletotheendofthethreadpipe) Ifexceed13mm,Pleasecuttherest Towrapthe taperoundthethreadpipeandtightthespout connectorwiththethreadpipe.
4. Remove the protective cover, Push the Dress Plate onto the body
Cement sheet andTiles 1
Disclaimer While we aim to ensure the spec fications shown are correct at the time of printing,AtticaAustralia reserves the right to make modificat ons without prior not ce 1 2
1.PushWallOutlettothespoutadaptorandfastenGrubScrews tosecureWallOutlet
2.FitMixerHandleintopositionandtightenGrubScrewto securehandle
3.FitCapintoPosition
MAINTENANCEAND CARE:
1. Products Should be cleaned with mild liquid detergent or soap and water
2. Do not use cream cleaners or citrus based cleaning products, as they are abrasive
3. Use of unsuitable cleaning agents may damage the surface. any damage caused in th s way will not be covered by warranty