PMMA XT General properties Density Water absorption 24h/23°C 50x50x4mm3 Ball indentation hardness Forming temperature air pressure Forming temperature vacuum Moulding shrinkage
Test method DIN EN ISO 1183 DIN EN ISO62-method 1 DIN EN ISO 2039-1
Unit g /cm3
Mechanical properties Tensile strength Elongation at break Tensile modulus Flexural strength Flexural modulus
Test method DIN EN ISO 527-2 DIN EN ISO 527-2 DIN EN ISO 527-2 DIN EN ISO 178 DIN EN ISO 178
Value 70 4 3100 110 3000
Impact strength Charpy unnotched
DIN EN ISO 179-1
Unit MPa MPa MPa MPa MPa kJ / m2 2
2 Value 92 1,492
Impact strength Charpy notched Optical properties Light transmission (3 mm) Refractive index Total solar energy transmission (g -Wert) Gloss value Thermal properties Vicat temperature (B 50) (Pre-treatment 16h at 80°C)
Specific heat capacity Linear thermal expansion Thermal conductivity Service temperature continuous use Max. temperature short term use Degradation temperature Electrical properties Surface resistivity Volume resistivity Electrical strength Dielectric strength Dielectric dissipation factor 50 Hz / 1 KHz/ 1 MHz
Relative permittivity 50 Hz / 1 KHz / 1 MHz Other properties Fire resistance Fire performance Food contact - GMP Biocompalibility
DIN EN ISO 179-1 Test method DIN 5036-3 DIN EN ISO 13468-2
DIN EN ISO 489 DIN EN 410 DIN 67530 Test method DIN EN ISO 306 DIN EN ISO 11357-4 DIN 53752, ISO 11359-2
% MPa °C °C %
kJ / m
Value 1,19 0,2 235 140-160 160-190 0,5-0,8
15
Unit % n20D
DIN 52612, DIN EN ISO 22007-1
W/mK °C °C °C
86,5 >100 Value 105 1,47 0,07 0,18 70 90 280
DIN EN 62631-1-3-, IEC 60093
Ω Ωxm kV/mm kV/mm
3x1015-3x1016 1x1013-5x1013 10 30
DIN EN 62631-1-3-, IEC 60093
DIN EN 60243-1, IEC 60243-1 DIN EN 60243-1, IEC 60243-1 DIN 53483-2 DIN 53483-2
UL94
% Unit °C J/gK
mm/m x°C
0.06 I 0.04 I 0.02
2.7/3.1 /2.7 HB
classification
CPD 305/201, DIN EN 13501-1 classification E, No burning droplets EU directive 1935/2004, Regulation 10/2011
DIN ISO 10993-5
Conform No cytotoxic
Material data is collected in good faith from our suppliers, alternatively from raw material manufacturers, and may differ depending on the test method used. To ensure the respective value. Nordic Plastics Group disclaims all responsibility in connection with the use of the data
Nordic Polytech Group, Omvägen 17, SE-231 61 Trelleborg, Sweden. Tel +46 (0)10-707 80 00 www.npgroup.se Version: 2022