The goods

Important

1. Do not tighten bolts / screws completely until all bolts / screws are lined up and inserted into holes.

2. Do not over tighten screws and bolts to avoid stripping.

3. Please use hand tools to assemble this product. Do not use power tools.

Pre-Installation

• Read all instructions prior to beginning assembly.

• To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.

• Keep the receipt and these instructions for proof of purchase.

• Suggested Bulb: ST19 LED 60 Watt Equivalent | E26 Medium Base | Dimmable

• Fixture Max Wattage: 60W

Step 1

Get ready for some exciting DIY action! Lets start by seperating the Mounting Plate (H) from Canopy (4) by unscrewing the Finial Nuts (E).

Step 2

Next, place the Mounting Plate (H) in the desired location on your wall. Use the holes as a guide to mark where you will drill the holes for the wall anchors.

Step 3

Using a drill + proper drill bit & the reference marks from Step 2, drill 3 holes into the wall.

IMPORTANT NOTE:

Non-drywall = 1/4” Drill Bit

Drywall = 5/16” Drill Bit

Step 4

Go ahead and tap the proper wall anchors into place in the new holes you just drilled. You may be able to push them into place with your thumb.

IMPORTANT NOTE:

Non-drywall Anchors = B

Drywall Anchors = C

Step 5

Mount the Mounting Plate (H) to the wall by screwing the proper screws, dependent on the wall type, into the wall anchors.

IMPORTANT NOTE:

Non-drywall Anchors = A

Step 6

Halfway there! Remove hardware components from the back of the fixture (2).

D

Step 7

Using the hardware components that you just removed in Step 6, secure the Canopy to the Fixture with the Decorative Plate sandwiched between each component.

Step 8

Insert vertical fiture tube into its respective housing on the Fixture.

Double check that ever yt hing is level!

Double check that ever yt hing is aligned!

Step 9

Once the vertical fixture tube is properly aligned within its respective housing, secure it in place by tightening the set screw on the side of the housing.

Step 10

Secure Fixture to the Mounting Plate using the Finial Nuts.

Then remove the shade collar by unscrewing it from the socket assembly.

Step 11

Secure shade in place by screwing the shade collar back into place, sandwiching the shade between the shade collar and socket assembly.

Troubleshooting

Problem

The bulb will not light. The fuse blows or circuit breaker blows when the light is turned on.

Possible Causes

The bulb is burned out.

The power is off.

The circuit breaker is off. There is an exposed wire.

Solutions

Replace the light bulb.

Ensure the power supply is on.

Ensure the circuit breaker is in the ON position. Discontinue use of the light. Contact a qualified electrician or reach out to our Customer Happiness team at help@nathanjames.com or 1-866-619-1004.

Step 12

Screw in your preferred light bulb. We recommend using 1 Type ST19 light bulb. 120V 60Hz Ac only.

Bulb (not included)

Step 13

Congrats! You’ve made it to the final step. Adjust the height of your shade by feeding more or less cord through the fixture.