The goods

Important

1. Do not tighten bolts / screws completely until all bolts / screws are lined up and inserted into holes.

2. Do not over tighten screws and bolts to avoid stripping.

3. Please use hand tools to assemble this product. Do not use power tools.

Pre-Installation

• Read all instructions prior to beginning assembly.

• To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.

• Keep the receipt and these instructions for proof of purchase.

• Suggested Bulb: G16.5 LED 60 Watt Equivalent | E26 Medium Base | Dimmable

• Max. Wattage: 180W (60W per bulb)

Step 1

Okay, let’s get started! Begin threading support tubes onto the Fixture (1).

Step 2

Remove hardware from the back of the support tubes.

Step 3

Using the hardware that you just removed from the support tubes, secure the Wall Plate (2) to the Fixture (1) using the Wrench (D).

Remove the M4*15mm Screws (E) from Mounting Plate (C). These will be used again in a later step.

You’re halfway there! Now install Mounting Plate (C) to your preinstalled Electrical Box using the M4*26mm Junction Box Screws (A).

Step 6

Note: Be sure that you are only making the connections to a 120V AC 60Hz circuit. If you do not have a pre-existing electrical box, we strongly advise using a certified electrician.

Step 8

Use Wire Nuts (B) to join the remaining matching colored wires (White to White, Black to Black).

Once complete, tuck the excess wire into the Electrical Box.

White (Neutral)

Secure the Fixture (1) to the Mounting Plate (C) on your preinstalled Electrical Box using the M4*15mm Screws (E) that you originally removed in Step 4.

Step 10

You did it! Now all that’s left to do is install the light bulbs. We recommend using three Type G16.5 bulbs (not included).

Use 3 Type G16.5 Bulbs (not included) 120V 60Hz AC Only

Troubleshooting

Problem

The bulb will not light. The fuse blows or circuit breaker blows when the light is turned on.

Possible Causes

The bulb is burned out. The power is off.

The circuit breaker is off. There is an exposed wire.

Solutions

Replace the light bulb.

Ensure the power supply is on.

Ensure the circuit breaker is in the ON position. Discontinue use of the light. Contact a qualified electrician or reach out to our Customer Happiness team at help@nathanjames.com or 1-866-619-1004.