The goods

Important

1. Do not tighten bolts / screws completely until all bolts / screws are lined up and inserted into holes.

2. Do not over tighten screws and bolts to avoid stripping.

3. Please use hand tools to assemble this product. Do not use power tools.

Pre-Installation

• Read all instructions prior to beginning assembly.

• To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.

• Keep the receipt and these instructions for proof of purchase.

• Suggested Bulb: Type G50

• Max. Wattage: 120W (60W per bulb)

Step 1

Okay, time to get started! Don’t worry, we made the first step extra easy. Thread the middle post section into the back of the Fixture (1) and remove the Socket Rings (2).

Helpful tip: Righty-tighty, lefty-loosey!

Secure the back plate of the Fixture (1) to the middle post section using the provided hardware. Tighten with the Wrench (D).

Step 2 Step 3

You’re doing great! Are you a professional or something? Now it’s time to attach the Shades (3) to the Fixture (1) using the Socket Rings (2).

Step 4

You’re almost halfway done! Time for a snack break…

Okay, back to work. Now it’s time to make sure your fixture will be nice and level when it’s installed. To do this, turn the round plate on the back of the Fixture (1) to ensure the holes in the round plate are horizontal/level. You can place the Fixture on a table top to help with this step. Once the holes in the plate are horizontal, secure the nut on the back of the round plate using the Wrench (D).

Remove

Step 5 Step 6

Okay, now for the fun part. Install the Cross Bar (C) to your pre-installed electrical box using the Junction Box Screws (A). Tighten using a Phillips head screwdriver.

Note: Be sure that you are only making the connections to a 120V AC 60Hz circuit. If you do not have a pre-existing electrical box, we strongly advise using a certified electrician.

Step 7

Now wrap the ground wire around the grounding screw on the Cross Bar (C). Secure by tightening the screw using a Phillips head screwdriver.

Step 8

Join the matching colored wires (white to white, black to black, and ground to ground) with Wire Connectors (B). Tuck the excess wire into the electrical box.

Step 9

Now it’s time to secure the Fixture (1) to the Cross Bar (C) on your pre-installed electrical box using the Decorative Nuts (E). Be sure that you have all of the excess wire tucked into the electrical box.

Step 10

Now for the final touch: install the light bulbs! We recommend 2 type G50 bulbs.

And voila, let there be light!

Troubleshooting

Problem

The bulb will not light. The fuse blows or circuit breaker blows when the light is turned on.

To properly fasten the Decorative Nuts (E), thread in or out to adjust for proper threading length.

Possible Causes

The bulb is burned out.

The power is off.

The circuit breaker is off. There is an exposed wire.

Use 2 Type G50 bulbs (not included) 120V 60Hz AC only

Solutions

Replace the light bulb.

Ensure the power supply is on.

Ensure the circuit breaker is in the ON position. Discontinue use of the light. Contact a qualified electrician or reach out to our Customer Happiness team at help@nathanjames.com or 1-866-619-1004.