The goods

Important

1. Do not tighten bolts / screws completely until all bolts / screws are lined up and inserted into holes.

2. Do not over tighten screws and bolts to avoid stripping.

3. Please use hand tools to assemble this product. Do not use power tools.

Pre-Installation

• Read all instructions prior to beginning assembly.

• To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.

• Keep the receipt and these instructions for proof of purchase.

• 120V 60Hz AC Only

• Suggested Bulb: ST19 Vintage LED 60 Watt Equivalent | E26 Medium Base | Dimmable

• Fixture Max Wattage: 60W

Step 1

Let’s get this thing fired up! Attach Fixture Finial (2) to Fixture (1). Remove Decorative Screws (4) from the Fixture (1).

Step 2

Step 3

Line up holes on the Glass Shade (3) with the holes in the Fixture body (1) then secure the Glass Shade with the Decorative Screws (4) threading into the Fixture body.

P.S. We aren’t judging you if you’ve already pulled out your snack. Ours was eaten by Step 2.

Step 4

Separate the Finial Caps (E) & Ceiling Plate (A) from the Mounting Bracket (D).

Step 5

Weave the cord through the chain and then attach the chain to the Ceiling Plate (A) & Fixture Finial (2) at your desired cord & chain length.

Step 6

Install Mounting Bracket (D) to your pre-installed electrical box using the Junction Box Screws (C).

Note: Be sure that you are only making the connections to a 120V AC 60Hz circuit. If you do not have a pre-existing electrical box, we strongly advise using a certified electrician.

Step 7

Wrap the ground wire from the Fixture around the grounding screw on the Mounting Bracket and secure with a screw driver.

Step 8

Join matching colored wires with Wire Nuts (F).

Begin tucking the excess wire into the electrical box.

Thread in or out to adjust for proper threading length to properly fasten the Finial Caps on.

Step 9

Using the Finial Caps (E), mount the Fixture to the Mounting Bracket (D).

Be sure that you have all of the excess wire tucked into the Electrical Box.

And voila, you’re all done! Now you just need to screw in a bulb (we recommend ST-18 bulbs) and let there be light!

Troubleshooting

Problem

The bulb will not light.

Possible Causes

The bulb is burned out. The power is off.

The circuit breaker is off. There is an exposed wire.

Bulb (not included)

Solutions

Replace the light bulb. Ensure the power supply is on.

Ensure the circuit breaker is in the ON position. Discontinue use of the light. Contact a qualified electrician or reach out to our Customer Happiness team at help@nathanjames.com or 1-866-619-1004.