«
» Mk.I/III
AK 72018
Westland “Lysander” Mk.I/III British spotter / spy plane « . 1940
,
»
«
» ,
. 1941
. 1941
. « ,
,
1938
, » ,
,
, ,
,
.
,
1674
.
The “Lysander” multirole plane entered production in Great Britain in April 1938 in three baseline models. It fought for the first time in France in 1940 in the attack and reconnaissance roles. Then “Lysanders” were used in North Africa and Burma, and had been used for delivering Special Operations Executive agents and cargo deep behind the German lines. The aircraft in service with the Finnish Air Force entered the fighting in July 1941. Westland “Lysander” was widely used by armies of Great Britain, Ireland, Egypt, Canada, France, Turkey, India, Finland and Portugal. 1674 planes was manufactured in total.
DO NOT GLUE NICHT KLEBEN
BORE BOHREN
FILL HOLE SPACHTELN
GLUE FOR METAL KLEBSTOFF FÜR METALL
REMOVE ENTFERNEN
MAKE 2 SETS ZWEIMAL WIEDERHOLEN 2
OPTIONAL PARTS OPTIONALE TEILE
REPEAT FOR OPPOSITE SIDE FÜR LINKE UND RECHTE SEITE AUSFÜHREN
Внимание! ,
.
,
.
.
.
, .
. .
,
.
.
.
.
Осторожно! 8
!
-
.
.
.
3 ,
.
.
.
. . ,
.
.
Метод нанесения декалей: . ,
.
20 .
.
Attention! - Useful advice! Study the instructions carefully prior to assembly. Remove parts from frame with a sharp knife or a pair of scissors and trim away excess plastic. Do not pull off parts. Assemble the parts in numerical sequence. Use plastic cement ONLY and use cement sparingly to avoid damaging the model. Paint small parts before detaching them from frame. Remove paint where parts are to be cemented. Correct method for applying decals: Clean model surface with wet cloth. Cut each design out of decal sheet and dip them in warm water for 20 seconds. Check with fingertip if design is loose on base paper. If so, place it on proper position on model and slide off base paper leaving design on model. Move design to exact position with wet fingertip, and push out excess water and air bubbles under decal with soft cotton cloth. When decals get dry, wipe off with wet cloth excess glue left around decals.