ASSEMBLY INSTRUCTIONS
120 MIRRORED ARMOIRE
THIS FURNITURE MUST BE FIXED TO THE WALL ! WARNING
Children have died from furniture tip over. To reduce the risk of tip over:
LOT N°
ALWAYS secure this furniture to the wall using a wall anchor. NEVER allow children to stand, climb, or hang on drawers, doors or shelves. Do not defeat or remove the drawer interlock system. Place heaviest items in the lowest drawers. NEVER put a TV on this furniture.
To ensure the safety of those using this cabinet, it is crucial to properly secure it to the wall using a wall anchor . This product includes the necessary items for fixing the furniture to the wall. However, it is important to note that incorrect installation or failure to use the tip-over device can result in serious injury or even death. For this reason, we highly recommend that a professional installer handle the installation of the cabinet to the wall.
! IMPORTANT RECOMMENDATIONS
RECOMENDACIONES IMPORTANTES
Do not paint the cabinet.
No pintar el mueble.
The cabinet MUST be used exclusively indoors, do not expose to direct sun.
El mueble debe ser usado únicamente en interiores, no exponer al sol directo.
Clean metallic hardware with a dry cloth.
Limpiar los herrajes metálicos con un paño seco.
Do NOT overload the cabinet (see suggested loads). NO sobrecargar el mueble (ver las cargas sugeridas).
Do not hit or hammer the cabinet (just when indicated).
No golpear ni martillar el mueble (solo cuando se indique).
Clean with a slightly damp cloth, use gentle soaps.
Limpiar con un paño ligeramente húmedo, usar jabones suaves.
Do not drag, lift and move between two people.
No arrastre el mueble, levántelo entre dos personas.
Avoid direct contact with water, fire or exposure to heat sources.
Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor.
!
!
WARNING
ADVERTENCIA
Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death.
Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte.
Page 2
INDEX
ÍNDICE
Assembly Hardware
4
Herrajes para Armado
4
Assembly Parts
5
Piezas de Armado
5
Suggested Loads
6
Cargas Sugeridas
6
Assembly Recommendations
6
Recomendaciones de Ensamble
6
Assembly Steps
7-28 Pasos de Armado
7-28
Warranty
29
29
REQUIRED TOOLS*
Garantía
HERRAMIENTAS NECESARIAS*
5/16"
*Not included, and not shown actual size.
Page 3
*No incluidas y no se muestran en tamaño real.
ASSEMBLY HARDWARE
HERRAJES PARA ARMADO
Please check that the hardware content is correct. If any item is missing, please call to our customer service line.
Compruebe que el contenido de los herrajes sea el correcto. En caso de que falte alguna pieza, por favor llame a nuestra línea de atención al cliente.
x72
x51
x51
x51
x6
Wood Dowel Tarugo
Spreading Bolt Perno Minifix
Minifix Cams Minifix
Cover Caps Tapa Adhesiva Minifix
Full Overlay Hinge (Screws included)
Bisagra Parche
10
X
2
1/2
(Incluye Tornillos)
x3
x3
x10
x8
x4
Half Overlay Hinge
Chazo Mariposa+ Tornillo Ensamble Drywall Screw+ Wall Anchor
Nail-on Glide Deslizador Puntilla
2" Drywall Screw Tornillo de Ensamble 2"
Flat Head Screw Tornillo Lámina
x5
x1
x9
x2
x1
Handle
Guide Profile Perfil H/
Shelf support Soporte Entrepaño
Drawer Slides (Screws included)
Closet Rod Tubo Ovalado
(Screws included)
Bisagra Semi-Parche
(Incluye Tornillos)
(Screws included)
Manija
(Incluye Tornillos)
x2
x1
Rod Support Soporte Tubo
Mirror + tape Espejo + cintas
Hardware items are NOT shown actual size.
Page 4
Riel
(Incluye Tornillos)
Los herrajes no se muestran en el tamaño real.
ASSEMBLY PARTS
PIEZAS DE ARMADO B J X U
U V
G F
C T K
S
K
M
V
Y
N
X L
F
L
M R
J X W
A O O
H P
A - x1 B - x1 C - x1 D - x1 E - x1 F - x2 Page 5
I
G - x1 H - x1 I - x1 J - x2 K - x2 L - x2
D
N
S Q
E
M - x2 N - x2 O - x2 P - x1 Q - x1 R - x1
S - x2 Y - x1 T - x1 U - x2 V - x1 W - x1 X - x3
MAX SUGGESTED LOADS
44 lbs.
17,6 lbs.
20 Kg.
8 Kg.
17,6 lbs.
8 Kg.
17,6 lbs.
8 Kg.
5 Kg.
5 Kg. Kg. 5
11,02lbs. 11,02lbs. 11,02lbs.
CARGAS MÁXIMAS SUGERIDAS
11,02lbs.
22 lbs
5 Kg.
10 Kg.
ASSEMBLY RECOMMENDATIONS
RECOMENDACIONES DE ENSAMBLE
Two people are recommended to assemble the product.
Ensamble el mueble entre dos personas.
Assemble the cabinet on a flat, smooth surface, preferably on a carpeted floor or the carton box of the product.
Ensamble el mueble sobre una superficie plana y lisa, preferiblemente sobre un tapete o el cartón de la caja
Carefully read the assembly instructions and identify every wood and hardware part before start assemblying the cabinet.
Lea cuidadosamente las instrucciones e identifique todas las piezas y herrajes antes de empezar a armar el mueble.
Page 6
1
W
Repeat this in the following steps. Repita esto en todos los ensambles
2
Rotate Voltear
W
Page 7
3
I
4
H
Page 8
5
Gently hit the pieces to adjust the joint. Golpee suavemente la pieza para ajustar el ensamble.
I H w 2
6
1
A
Page 9
Rotate to tighten. Gire para apretar.
7 I
H W
A
8
Rotate Voltear
A I
Page 10
W
16
4
9 Fron t Fre nte
Half Overlay Hinge Bisagra Semi-Parche
E
10
Rotate Voltear
E
Page 11
11
G
12
X x3
Page 12
13
Jx2
14
Y
Page 13
15
X
Y
Rotate to tighten. Gire para apretar.
16 J
G
J
Page 14
E
Rotate to tighten. Gire para apretar.
17 J X G
E
Y X
J X
18 J X E
G
Y X
I A W Page 15
Rotate to tighten. Gire para apretar.
J X H
19
Full Overlay Hinge Bisagra Parche
D
20 J G I H A W
Page 16
E Y X
X D
Rotate to tighten. Gire para apretar.
21
Slide the back panels inside the cabinet Deslice los fondos dentro del mueble
Y D E I
J
G H W A J T 16
4
22
Fron t Fre nte
C
Full Overlay Hinge Bisagra Parche
Page 17
23 Rotate to tighten. Gire para apretar.
C
J Y
G I A W
24
E D
H
CAREFULLY FLIP THE FURNITURE / VOLTEAR EL MUEBLE CUIDADOSAMENTE
!
X D
E X
V
J
Rotate to tighten. Gire para apretar.
X I
Page 18
A H
JT W
C Tighten up all back Minifix Cams Ajuste todas los Minifix posteriores
1
V D J U
V X A H
U C JT W
26
B
Page 19
U U
Slide the back panels inside the cabinet Deslice los fondos dentro del mueble
E X
U
T
Guide Profile Perfil H
I
U
T
25
2
27
B
X
D V X V U
J
X I
A U H
J
T
W
C
Page 20
Rotate to tighten. Gire para apretar.
28
Fix your cabinet to the wall / Fija el mueble a la pared 1 You must drill the bottoms guided by the holes in the structures wiht a 3/16" drill bit.
Debes perforar los fondos guiandote de las perforaciones delas estructuras con una broca 3/16".
2 On the wall, measure and mark the points shown below
En la pared, mide y marca los puntos que te indicamos abajo.
3 Drill on the markings with a 5/16" drill bit.
Debes perforar en los puntos con taladro y una broca de 5/16".
Insert the wall anchors inside the drillings. 4 Inserta los chazos plásticos en las perforaciones. Place the cabinet and secure it with the screws. 5 Ubica el mueble y asegúralo con los tornillos.
* Inches / Centímetros 8.34" 21,2 2,55" 6,5
68,5" 174,1
Page 21
15,1" 38,4
J
15,7" 40
8" 20,4
X
29 Kx2 Lx2
30 Mx2
Page 22
31 x2
2" N
K
M L
32 x2
S K
M N
Page 23
L
33 O X2 x4 Voltear Rotate
O X2
34 x2 N
K S O
Page 24
Rotate to tighten. Gire para apretar.
L
35 x2 Tornillo Lámina Flat Head Screw
S
M
K L
O
36 R
Q x4
Page 25
37
Do a right cleaning of the surfaces, then place the mirror on the piece Limpiar bien las superficies y pegar el espejo sobre la pieza
1
Apply pressure on the and tapes Hacer presión sobre el espejo y las cintas
3
3,5" 8,9
2
8,66" 22
2,3" 6
49,2" 125
P
38 12,6" 32,1
P
x2 Page 26
3,5" 8,9
Instalación de las puertas Door Installation
39 1
B
Q C
C
E U
Q
D R Y
G A I
P
Hinge adjustment Ajuste de las bisagras
2
Depht adjustment Ajuste de profundidad
Page 27
4
3
Side adjustment Ajuste lateral
5
Height adjustment Ajuste de altura
40 B Q
R
F
D
Y
O
S
F
O I Slide the drawers inside the cabinet. Deslice los cajones dentro del mueble.
Slide the shelves inside the cabinet. Deslice los entrepaños dentro del mueble.
After you finish the adjustment of the cams, cover them with the cover caps. Después de ajustar todas las cajas minifix, cúbralas con las tapas adhesivas.
Page 28
P
A
After you finish assembling the cabinet, take off the adhesive letters. Al terminar de armar, desprenda las letras adhesivas.
WARRANTY POLICY
Furniture has a 1 year warranty coverage in wooden parts and hardware pieces since its manufacturing date, which you can see in the lot number printed on the product box and the assembly instructions leaflet. Warranty covers materials and workmanship imperfections which impair the assembly or correct functioning of the cabinet. This warranty is not valid if the defects or imperfections are caused by the incorrect following of the assembly instructions, warnings and recommendations, misuse, intentional damage, fire or flood, or after modifications or any kind of alteration, or repaired by someone not authorized, when it´s been assembled 3 months after the date of purchase. These defects MUST be reported before the warranty coverage period ends. Once the product has been assembled, the company will not be responsible for defective and/or damaged parts. This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the product has been resold, rented, etc. Furniture will take no liability for incidental or consequential damages caused to or by the product (This may not apply in your state). To make this warranty valid you must write to our customer service email describing the product defect, lot number and submitting your sales reciept or proof of purchase, or contact us at our customer service line. Replaced parts will be under the product´s original warranty coverage period. Damaged parts will become property of the company. There are no other warranties applicable to this product.
Page 29