HD DEGREASER HEAVY-DUTY ALKALINE CLEANER AND DEGREASER. REMOVES TIRE-MARKS, SMOKE/SOOT DEPOSITS AND GREASE/GRIME FROM CONCRETE, MASONRY, STONE, WOOD AND MORE.
● Removes grease, grime, oil, tar, tire marks and soot with minimum scrubbing. ● Contains no CFCs. Readily biodegradable in both water and soil, with accumulation not expected. ● Excellent detergency and oil coupling. ● Non-Flammable – Flash Point > 200° F. ● Low Odor. Non-hazardous. DESCRIPTION: Foxfire HD Degreaser is a water-based, alkaline solution of anionic oil-splitting surfactants used for heavy-duty cleaning, degreasing and grime removal. Foxfire HD Degreaser can be used on concrete, painted steel, steel, copper, aluminum, galvanized steel, bronze and plastic surfaces. TYPICAL APPLICATIONS: Building Maintenance: Remove paint oxidation and smoke from walls and ceiling. Transportation: Remove brake dust, soot and paint oxidation from equipment, RV’s and trucks. Boating: Remove oxidation and fouling from fiberglass, aluminum and paint.
Industrial: Remove heavy oils, greases, flux, waxes, cleaning and rubbing compounds, adhesives, dyes, paints. SAFETY PRECAUTIONS: Caution: always keep out of the reach of children. Signal Word-Warning; causes skin irritation; causes severe eye irritation.
Read SDS before use. Use only in a very well-ventilated area. NEVER MIX WITH ANY OTHER CLEANER OR CHEMICAL. Avoid breathing of vapor or spray mist. Use eye protection; minimize skin contact by wearing gloves and protective clothing. Use NIOSH cartridge mask. APPLICATION PRECAUTIONS: Read label, technical data sheet and safety data sheet prior to use. Always test, in an inconspicuous area, to determine the suitability of the product for the intended use. May
Page 1
damage sound painted surfaces after prolonged contact. Fully protect all adjacent and surrounding surfaces, foliage, vegetation, surrounding buildings, polished marble, copper, brass, bronze, metal, glass and painted surfaces during the cleaning process. Cover landscaping and continuously wet foliage with water before and during the cleaning process. Divert traffic or block area if needed. Product should be applied when surface and air temperatures are 40° F or above. If freezing has occurred, allow the substrate to thaw completely before application. Do NOT allow cleaner to dry on surfaces. Keep container closed when not in use. APPLICATION: Shake well. Application temperature range 40-90ºF. Mechanically remove as much buildup as possible prior to application. If applying in high temperatures, or in direct sunlight, prewet the surface. Apply cleaner liberally with a low-pressure (2550 psi) chemical-resistant sprayer or a masonry washing brush. Let product work on surface for 5-10 minutes. Do NOT allow product or residue to dry on surface and rewet any areas that have started to dry. Using a stiff brush, scrub treated areas and thoroughly rinse with high-pressure water (1000-3000 psi, 4-5 gals per min, depending on surface). Repeat process as needed, making sure that all product is thoroughly rinsed from the surface. Cycle cleaning and rinsing may be necessary. CLEAN UP: Clean tools, equipment with water. Water flush all primary surfaces, shrubbery, sidewalks, blacktop, asphalt, glass, equipment and all adjacent surfaces. Dispose of empty containers according to federal, state and local guidelines SPILLS AND DISPOSAL: Large: Dike and contain. Small: Soak up with an absorbent and place in approved container for disposal. Check local, state, and federal regulations for waste disposal. Maintain adequate ventilation to maintain PEL.
Foxfire SB-40 TDS Rev: 02/21