International Journal for Research in Applied Science & Engineering Technology (IJRASET)

ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.538

Volume 11 Issue III Mar 2023- Available at www.ijraset.com

2) Investigation of physico-chemical aspects of collected samples. To find pH, Electrical Conductivity, Chlorides, Total Dissolved Solids (TDS), Total hardness, Dissolved Oxygen (DO), Calcium, Magnesium, Sodium, Potassium and Alkalinity.

3) Comparative data between OW and BW in relation with water quality standard.

4) To study the water sample analysis in two rainy seasons (June 2010 to Sept. 2010, June 2011 to Sept. 2011) and one summer season (Feb. 2011 to May 2011).

5) Survey and selection of sites for ground water samples Open well and bore well (OW and BW) which mainly includes in Dhule city and Deopur region.

6) Investigation of physico-chemical aspects of collected samples. To find pH, Electrical Conductivity, Chlorides, Total Dissolved Solids (TDS), Total hardness, Dissolved Oxygen (DO), Calcium, Magnesium, Sodium, Potassium and Alkalinity.

7) Comparative data between OW and BW in relation with water quality standard.

8) To study the water sample analysis in two rainy seasons (June 2010 to Sept. 2010, June 2011 to Sept. 2011) and one summer season (Feb. 2011 to May 2011).

9) Volumes in Saskatchewan, Saskatchewan Water Corporation.

III. NEED TO CHECK/EXAMINE WATER QUALITY OF SCHOOL / COLLAGE

1) Drinking water quality varies from place to place, depending onhe condition of the source water from which it is drawn and the treatment it receives.

2) The need of this study was to identify the prevalence of school water quality, availability, and education-related practices, and determine whether there were differences in those practices by school characteristics.

IV. COLLECTION OF WATER SAMPLE

1) Before testing the sample are collected from the source ofwater. These sample should be collected from such places that they represent the body of the water from which they are collected.

2) Following points should be kept in view while collecting the sample If water is to be collected from the Tap, sufficient quantity of water should be allowed to pass through the Tap, before collecting sample from it. Because it will eliminate the stagnant water.

3) If water is to be collected from the surface stream or rers, it should becollected above 30-50 cm below, thE surface, to avail the collection ofsurface impurities, oils, tree leaves etc. Which are also remove by stainerwhile collecting the water through intake

4) In case of water in being collected from the ground source i.e throughwell or tube well, sufficient quantity of water should be pump out beforecollecting the samples.

V. METHODOLOGY

Parameter Method Use pH

Electrical Conductivity

Alkalinity

Total Hardness, Ca, Mg

Total Dissolved Solid

Dissolved Oxygen

Digital pH Meter

Digital Conductivity Meter

Titration Method Used HCL

EDTA Complexometric Method

Gravimetric Method

Titrimetric Method

Sodium, Pottasium Flame Photometer

Chloride Content

Titrimetric Method Using Stand AgNO3 Sollution

VI. SCOPE

1) Having read and seen so many problems and reports on the local news papers and the local media channels on unfit ground water. The research was thought of addressing this problem.

2) The second important factor for selecting this problem is the acute shortage of water due to limitations of stored water reservoirs like lake, ponds or rivers around Dhule city as a resource.