International Journal for Research in Applied Science & Engineering Technology (IJRASET)

ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.538

Volume 11 Issue II Feb 2023- Available at www.ijraset.com

III.ANALYSISUSINGSTAADPROV8I

Staad Pro V8i SS5 software was used to analyze and design pre-engineered building structures and conventional structures in this project. In the second example, an 88m wide 2D flat frame with conical sections is designed for PEB, this structure cannot be built using the conventional method as it is not feasible or economical for the project. Different spacings between bays were considered to verify the adequacy.Staad pro V8i SS5 comes with various tools and modes for us to take advantage of a user- friendly interface. Design and analysis can be done side by side to check for errors in the designs. For PEB design, different dimensions of Conical Isections can be verified for a stable and optimized structure and the same is for conventional steel design, where pre-rolled sections with commercial dimensions are accessible for design and analysis purposes. STAAD Pro software can be used to analyze and design pre-engineered buildings. It can analyze the bending moment, axial forces, shear force, torsion, beam loads of a steel structure, so that the design can be done with conical sections and checked for safety.

IV.CONCLUSION

Based on the above study following conclusions can be made

1) Research shows that PEB structures are easy to design. These designs are effective and result in rapid construction.

2) The properties of steel, stainless steel, aluminum and concrete materials are presented in

3) And the total load is applied to the geometry

4) The resulting maximum displacement beam is 0.530

V. ACKNOWLEDGMENT

This work was completed with the grants and facilities of Lakshmi Narain College of Technology, Bhopal (M.P.). Authors are thankful to this institute and faculties for extending this cooperation.

References

[1] Apurv Rajendra Thorat, Santosh K. Patil (2017)" A STUDY OF PERFORMANCE OF PRE-ENGINEERED BUILDING OF AN INDUSTRIAL WAREHOUSE FOR DYNAMIC LOAD" International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395 -0056

[2] Arote et al. (2022) "ADVANTAGES OF PRE-ENGINEERED BUILDING OVER CONVENTIONAL STEEL BUILDINGS." (2022). International Journal of Scientific Research in Engineering and Management (IJSREM) Volume: 06 Issue: 01 | Jan - 2022 ISSN: 2582-3930.

[3] B. Rouwenhorst et al.(2000)" Warehouse design and control" Framework and literature review,European Journal of Operational Research,Volume 122, Issue 3,2000, Pages 515-533, ISSN 0377-2217,https://doi.org/10.1016/S0377-2217(99)00020-X https://www.sciencedirect.com/science/article/pii/S037722179900020X).