hts
Hot Tub Pre-Installation Guide 32amp
1. Access Make sure there is suitable access for the delivery of the hot tub. Please refer to our preparation videos & guides for advice on this. Any questions please call us.
2. Prepare Your Surface We recommend a flat concrete base which is 10-15 cm deep. please remember the dry weight of an average hot tub design is 350 to 500 KG & therefore after water, the weight will be near to 2 tonnes.
3. Prepare The Location Of Your Hot Tub Location is very important part of this process, hot tubs as mentioned above are very heavy & even heavier when full of water. Please do not consider them to be like a sofa & can be moved every time you need a change, please consider your new spa as a part of the house like a extension & therefore more permanent.
4. Prepare Your Electricity Supply You will require a 6mm armoured cable with a 32amp feed. The cable needs to be long enough to reach the hot tub from the isolator. Please take extra care & ensure there is sufficient length of cable available for the engineer to connect to the hot tub.
From Main Electric Supply
Cable To Be Connected To Hot Tub
5. Water Supply The water flow needs to be sufficient enough to ensure the hot tub is filled in minimal time.
www.hottubsuppliers.com - service@hottubsuppliers.com - 0116 2513378