PERIODIC MAINTENANCE AND ADJUSTMENT

to chain slippage or breakage. To prevent this from occurring, keep the drive chain slack within the specified limits. [ECA10571]

Locknut:

16 Nm (1.6 m·kgf, 11 ft·lbf)

Axle nut: 90 Nm (9.0 m·kgf, 65 ft·lbf)

Cleaning and lubricating the drive chain

Tip

Using the alignment marks on each drive chain puller, make sure that both drive chain pullers are in the same position for proper wheel alignment.

3.Tighten both locknuts and the axle nut to the specified torques.

The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it will quickly wear out, especially when riding in dusty or wet areas. Service the drive chain as follows.

Notice

The drive chain must be lubricated after washing the motorcycle and riding in the rain or wet areas.

1.Remove all dirt and mud from the drive chain with a brush or cloth.

Tip

For a thorough cleaning, have a Yamaha dealer remove the drive chain and soak it in solvent.

2.Spray Yamaha Chain and Cable Lube or a high-quality spray-type drive chain lubricant on the entire chain, making sure that all side plates and rollers have been sufficiently oiled.

EAU41842

Checking and lubricating the cables

The operation of all control cables and the condition of the cables should be checked before each ride, and the cables and cable ends should be lubricated if necessary. If a cable is damaged or does not move smoothly, have a Yamaha dealer check or replace it. WARNING! Damage to the outer housing of cables may result in internal rusting and cause interference with cable movement. Replace damaged cables as soon as possible to prevent unsafe conditions.

[EWA10711]

Recommended lubricant:

Yamaha Chain and Cable Lube or 4stroke engine oil