1 minute read
SWING
Tigercat 830 Feller Buncher Safety
SERVICING SAFETY PRECAUTIONS
Conduct maintenance inspections at least as frequently as recommended in section 3 of the OPERATOR'S MANUAL. When servicing or repairing equipment, shut the engine down. Turn Master Disconnect switch OFF. Install a “DO NOT START ENGINE” sign on the operator’s cab door and in the engine compartment when making repairs to the machine.
Before performing maintenance or repair work on any equipment, consult the manufacturer’s instruction manual and follow recommended procedures. The radiator and the engine cooling system should be cleaned and serviced daily to maintain moderate engine temperatures.
Tigercat 830 Feller Buncher Safety
SERVICING SAFETY PRECAUTIONS continued
Prior to welding on any part of the machine, it should be cleaned and a fire extinguisher should be made available at the welding location. Care must be taken in attaching the welding machine grounding clamp so current does not pass through bearings, especially the swing bearing. Disconnect the negative (-) battery cable from all three batteries. This machine is equipped with sensitive electronic control equipment, prior to welding:-
Disconnect the multi-pin plug from the engine
anti-stall controller located on the rear inside wall of the cab.
DISCONNECT THE MULTI-PIN PLUG FROM THE ENGINE ANTI-STALL CONTROLLER DISCONNECT THE TWO MULTI-PIN PLUGS FROM THE ENGINE CPU
QSC AND QSL9 ENGINES ONLY
830-D39
ENGINE CPU DISCONNECT - LEFT SIDE OF ENGINE
from the left side of the engine. (Applicable on QSC or QSL9 engines only). Disconnect the IQAN display 6 pin connector and the control module 42 pin connector. (Applies only to machines with IQAN control system)
DISCONNECT THE 6 PIN PLUG FROM THE BACK OF THE DISPLAY MODULE
822-D03 ENGINE ANT-STALL DISCONNECT Disconnect the engine CPU (Central Processing Unit) by unplugging the two multi-pin connectors
DISCONNECT THE TWO MULTI-PIN PLUGS FROM THE ENGINE CPU
QSC AND QSL9 ENGINES ONLY
830-D38
ENGINE CPU DISCONNECT - LEFT SIDE OF ENGINE
APPLIES ONLY TO MACHINES WITH IQAN CONTROL SYSTEM
830-D36
IQAN DISPLAY DISCONNECT
ENGINE ANTI-STALL DISCONNECT PLUG
DISCONNECT THE 42 PIN PLUG FROM THE XP MODULE
APPLIES ONLY TO MACHINES WITH IQAN CONTROL SYSTEM
830-D37
