HYDRAULIC COMPONENTS DESCRIPTION

Tigercat 720 Feller Buncher Safety

SAFETY SYMBOLS

This safety-alert symbol is used throughout this manual and on labels on the machine to call your attention to areas in which carelessness or failure to follow specific procedures may result in personal injury and/or component damage or malfunction.

Understanding Signal Words

DANGER identifies the most serious hazards where failure to follow listed procedures would result in a high probability of death or serious injury.

WARNING denotes a hazard exists which can result in serious injury or death if proper precautions are not taken.

CAUTION is used in areas where failure to follow listed procedures may cause personal injury, component damage or subsequent malfunction.

DANGER

WARNING

CAUTION

Tigercat 720 Feller Buncher Safety

GENERAL SAFETY PRECAUTIONS

Remember that safety is a prime responsibility of all. To minimize the risks and promote safety at all times, this section of the operator’s manual details a number of safety rules which should always be followed and obeyed. Study all the safety messages in this manual and on the labels on the machine carefully. Follow all instructions from safety inspector and supervisors.

KEEP BACK 300 FEET

When approaching an operating machine on foot, stay at least 300 feet (90M) away until the operator recognizes your presence. Make sure that all harvesting equipment is shut down before advancing to the machine. Always avoid the discharge side of a felling sawhead. A sawhead's high-velocity discharge of debris requires a safe separation distance.

Wear a suitable hearing protective device such as earmuffs or earplugs to protect against noise. Prolonged exposure to loud noise can cause impairment or loss of hearing.

Use the handrails and steps provided when mounting and dismounting from the machine. Do not climb onto or jump off the machine at any time. Do not use the steering wheel as handle when entering or leaving the cab. When mounting or dismounting the machine always use the 3 point technique - Use one hand with 2 feet or 2 hands with one foot. Avoid mounting or dismounting the machine in areas with slippery surfaces. If this is not possible clean up or cover slippery surfaces with a non-slip material.

You must be fully trained to operate this piece of equipment. Know the capabilities and the limitations of the equipment. Learn the most efficient operating techniques. Do not let an untrained person operate the machine.

Use recommended protective clothing and safety devices such as gloves, safety boots, safety hat, goggles, and ear protection when necessary. These safety rules highlight both general and specific measures the operator should be familiar with and adhere to. More specific measures are illustrated with pictograms which may also be attached to the machine in locations pertinent to their respective message. Keep safety labels in good condition. Repair or replace damaged labels.

Tigercat 720 Feller Buncher Safety

GENERAL SAFETY PRECAUTIONS continued

Machines should be completely cleaned of debris at least daily, particularily around the engine exhaust components. Hydraulic oil leaks, excess grease, fuel and oil accumulation (including spillage) should be eliminated immediately. Machine should be washed completely at every major service. overhanging electrical powerlines are present. Serious injury or death by electrocution can result if the machine or any of its attachments are not kept a safe distance from these lines. Maintain a distance of 10 ft. (3m) between the machine or boom and any power line carrying up to 50,000 volts or less. Powerlines carrying more than 50,000 volts require a safety distance of 10 ft. (3m) plus 1/2 inch (10mm) for each addition 1,000 volts above the 50,000 volt level. If State/Provincial, local or job site regulations require even greater safety distances than stated above, adhere strictly to these regulations for your own protection. If the machine must be transported, make sure that it is adequately secured to the transporting vehicle. Even though the brakes are fully engaged, block the wheels to prevent movement during transport. Comply with instructions in this manual and also your company’s regulations for the operation of this machine.

Read, understand and follow all general safety

Keep a first aid kit in an easily accessible location on the vehicle at all times. Do not carry passengers either in the cab or anywhere else on the machine. The vehicle is provided and approved with seating for the operator only. Do not allow anyone to operate the machine who may not be physically fit or who may be under the influence of alcohol or drugs. Inspect the machine daily for signs of damage, unusual wear, fluid leaks, or faulty operation. Repair or replace malfunctioning parts and systems immediately. Do not operate the machine with any defective or inoperable components. Do not operate the machine with any of the exhaust system, safety covers, or other devices removed. When moving the machine, watch that enough clearance is available on both sides and above the machine or any of its attachments. Extra clearance may be required particularly where the ground is uneven. Approach with extreme caution any area where

Tigercat 720 Feller Buncher Safety

OPERATING SAFETY PRECAUTIONS

precautions specified by felling head manufacturer. Shut off engine when refuelling - DO NOT refuel the engine while smoking or near open flame or sparks. Before starting the engine, check to ensure that all doors, panels, and access covers are installed properly and secured.

Make sure that all of the controls are positioned as specified in the starting instructions in the operator's manual. Check that no other personnel have moved into a hazardous area before starting the machine. Sound the machine horn before starting the machine.

The operator’s seat is equipped with a seat belt. Use this belt at all times when operating the machine. Start the engine according to the instructions in this manual. Prior to commencing work, check all equipment controls to ensure that the machine responds correctly. Make sure that all safety screens including the skylight are installed and properly secured. Do not open an escape hatch or the cab doors to increase ventilation when operating the machine.

Keep the cab doors closed when driving or steering the machine to prevent accidental entry of branches and debris into the cab. Keep the cab doors closed and use seat belt when driving or steering the machine to prevent being thrown from the operator's cab.

Never use the parking brake to slow down or stop the machine except in an emergency. Keep the brake properly adjusted at all times. Always rest the felling attachment on the ground when operation is stopped, regardless if the engine is running or shut off.

When the engine is running, DO NOT allow anyone in areas of the machine where they may be crushed by moving components.