1 minute read
Model 6210 Maintenance Manual
Section 7.Component Procedures
Hydraulic Components Lift Cylinder
Installation
1.Install the hydraulic cylinder into the truck frame.
2.Attach the upper cylinder bracket using the two captivating bolts removed earlier.
3.Slide the chain yoke into the inner mast crosstie bracket. Make sure that the rubber washer is in place inside the bracket.
4.Install the two adjustable guide screws and jam nuts.
5.Reattach the hydraulic hose to the base of the cylinder.
6.Attach the lift chain to the chain bolt and secure with a new cotter pin.
7.Reconnect the battery connector. Place the Main ON/OFF Switch in the ON position. If equipped with the optional keypad, enter your PIN-key code and then press the green ON ( | ) key.
8.Operate lift to test for correct operation. Lift and lower several times.
9.Remove the block from under the fork carriage.
10.Check the hydraulic fluid reservoir level and fill as necessary.
Publication: 1146947, Revised: 12 Jan 2017 7-79
