Model 6210 Maintenance Manual

from Raymond 6210 Walkie Straddle Stacker Maintenance Manual SN 621-15-00100 & Up - PDF DOWNLOAD

Model 6210 Maintenance Manual

Section 7.Component Procedures

Electrical Components Switches

12.Adjust the switch if necessary.

13.If equipped with the optional keypad, press the red OFF (O) key. Place the Main ON/OFF Switch in the OFF position. Disconnect the battery connector from the truck.

14.Install the tractor covers.

15.Reconnect the battery connector.

Arm Angle Proximity Switch Adjustment

1.If equipped with the optional keypad, press the red OFF (O) key. Place the Main ON/OFF Switch in the OFF position. Disconnect the battery connector from the truck.

2.Remove the screws and control handle bumper stop to access the angle arm proximity switch.

3.Loosen the screws securing the proximity switch bracket to the tiller arm base. Slide the bracket toward or away from the cam surface of the raised tiller arm to adjust the gap. Correct gap between the switch sensing face and the raised tiller cam surface is 0.070 to 0.086 in. (2.0 +0.20 mm). See Figure7-69 .

5.Test the operation of the truck.

6.Install the control handle bumper stop [4] and grommet [2] using socket head locking screws [3]. Torque screws to 13 ft. lb. (17.6Nm). See Figure7-70 .

4.Reconnect the battery connector. Place the Main ON/OFF Switch in the ON position. If equipped with the optional keypad, enter your PIN-key code and then press the green ON (|) key.

Publication: 1146947, Revised: 12 Jan 2017 7-57

Section 7.Component Procedures

Converting from Keypad

1.Remove the tractor covers.

2.Using the service key (), change parameter 39 to 1 or 2.

3.If equipped with the optional keypad, press the red OFF ( O ) key. Place the Main ON/OFF Switch in the OFF position. Disconnect the battery connector from the truck.

4.Remove the screw from the keypad. Remove the keypad. See Figure7-71

5.Install the new keypad cover. Figure 7-71.Control Arm Cover Installed