4.SEPARATION OF THE FRONT TRANSMISSION AND SPACER TRANSMISSION

7) Remove the slow-return check valve knob Parts which can be inspected during This operation

-PTO clutch

-Linear shift gears and related parts

-Main change gears

1) Removal

A:Removal of the whole floor.

1) Remove the side covers(LH and RH).

2) Disconnect the negative battery cable.

3) Detach all the wiring relevant to the removal of the floor.

Slow return check valve

8) Remove the diff-lock pedal

4) Disconnect the throttle lever cable from the fuel injection pump and accelerator pedal cable from the pedal.

5) Disconnect the clutch rod and brake rods under the floor.

6) Disconnect the steering cylinder at the hydraulic pump pedal

9) Remove the parking brake.

10) Remove the main shift and transmission range shift levers.The levers can be separated in the middle.

11) Remove the control rods of the PTO shift and 4WD shift levers from the transmission.

12) Remove the position control levers.

13) When the tractor is equipped with an optional remote control valve,remove the remote control valve link.

14) Drain the fuel system of fuel.

15) Remove four rubber mounts.

16) Lift up the floor slightly with a hoist.

17) Disconnect the linear shift control cable, fuel hoses,and gauge coupler between the fuel tank and floor.

18) Lift the floor gradually taking care not to allow the shaft of the slow return check valve and its hole in the floor to interfere with each other.

Slow return check valve

Note:

Lift up the floor gradually making sure that all relevant wiring. Piping, and links are disconnected.

3) Disconnect the brake rods.

B: Division of the chassis.

1) Drain the transmission of oil

2) Remove the front wheel drive shaft

4) When the tractor is equipped with an optional remote control valve ,remove the remote control piping.

5) Remove the suction and delivery pipes.

6) Remove the delivery pipe for the PTO clutch.

7) Remove the reverse shift metal(support)

8) Hold the clutch housing and space transmission case with a crane or jack.

9) Remove the bolts which tighten the front transmission and spacer transmission cases.

10) Move the rear part of the tractor rearwards by turning the rear wheels by hand, and then the spacer and rear transmission assembly will be separated from the front transmission.

Note:

When moving the rear part of the tractor. be careful not to allow the garage jack to shift from the spacer transmission case.

Remarks

The rear transmission and spacer transmission cases should be separated and the reverse shift metal(support) removed in order to take care out or provide access to the main shift and transmission range shift gears. For further details,refer to Chapter 5. Transmission.

2.installation

Reassemble in reverse order of disassembly.

(1) Assemble the front and spacer transmission. Make sure that the turning lock of the PTO clutch is securely seated in the groove in the spacer transmission case.

(2) Install the reverse shift metal(support)

(3) Install the PTO clutch delivery piping.

(4) Install brake rods.

(5) Install the front wheel drive shaft.

(6) Position the floor taking care not to allow wiring or other parts to be pinched under it

(7) With the floor lifted up a little, install the fuel hose and fuel gauge coupler on the fuel subtank and connect the linear shift control cable.

(8) Fix the floor at the four rubber mounts.

(9) Install all levers,knobs, and Rods.

(10) Connect the power steering wheels.

(11) Connect the accelerator wires.

(12) Install wiring

(13) Connect the negative battery cable.

(14) Install the side covers(RH and LH)

(15) Fill the transmission case with oil

T290/T300T330/2810NEW : 32ℓ