T ire Changing Procedure

Caution

the tir e being r emoved not flat, high essur e air will r eleased when the tir e hose disconnected the valve stem. T o minimize air loss, install the valve stem cap the wheel valve the tir e stem stop the flow air the tir e upon r emoval the hose. Use caution and eye otection.

Note: both tires will flat should damage occur either tire damage severe that Run Flat operation cannot maintain suf ficient operating the damaged tire can disconnected and the air line plugged capped allow the good tire - This should done emer gency situations only

Note: Mark the alignment the tire valve stem the hub necessary .

Note: When removing hoses, store a clean, dry location prevent contamination and/or

WHEEL REMOV — STEER

Remove T ire Hose. Disconnect tire hose from valve stem, then disconnect hose from wheel valve.

Cap Wheel V alve the hubcap prevent wheel valve Rotate the tire with the hub that the valve the bottom (wheel valve

Remove the wheel nuts and wheel/tire assembly .

WHEEL REMOV — DUAL

Drive axle only . Remove control hose from the hub, then disconnect hose from wheel valve. Plug the air outlet the hub prevent contaminants from entering the system.

Disconnect the tire hoses from the wheel valve tee and plug cap the line with the appropriate

Remove the wheel nuts and wheel/tire assembly .

Wheel Inst Alla Tion

Note: The tire valve stem core cannot used vehicles equipped with the Dana T ire Pressure Control