OPERA TION

T roubleshooting

The following checks may used diagnose any problems which may arise with Remote Keyless Entry system

Remember check all

Lower the windows, turn the ignition key the OFF position and close the doors.

Stand near the driver ’ s side door , aim the transmitter the vehicle and operate both functions the transmitter Repeat for all

• a single function one transmitter inoperative, replace the transmitter .

• all functions any the transmitters are reprogram all transmitters and repeat the troubleshooting Refer the the T all functions all transmitters operate, stand approximately five feet from the vehicle (at several points around the vehicle), and check the operation all transmitters each point.

• one transmitter cannot programmed, replace the battery the transmitter . Refer the section.

• one transmitter does not operate some point where another transmitter does replace the battery the transmitter that does not

• all transmitters operate approximately five feet from the vehicle, the system operating properly and repairs should attempted.

Programming the T ransmitter:

T urn the ignition switch the position.

Access the keyless entry module, located behind the DPanel.

Push the Program switch the keyless entry module three The program LED the module will indicate you are now the T ransmitter Programming necessary , repeat Step 3 program the 2nd, 3rd and 4th transmitters.

Press any button one the transmitters until the horn responds with a chirp and the LED will flash once, confirm the first transmitter now programmed.

Note: more than four transmitters are the system will only retain the last four transmitters programmed.

T o exit Programming Mode, turn the ignition switch the OFF position, simply wait seconds. The LED will f confirm exit.

Feature Programming:

T urn the ignition switch the

Access the keyless entry module, located behind the DPanel.

Push the Program switch the keyless entry module six The horn will chirp six and the program LED the module will indicate you are now the Feature Programming

Press and release the transmitter button corresponding the feature you want change.

Note: The horn chirps and LED pulses will indicate the new setting.

Press the transmitter button again change the feature again. Keep pressing the transmitter button until the module advances your desired setting.

Press T ransmitter Button One Chirp/LED One Pulse Factory Default Setting T Chirps/LED T Pulses

The Remote function can operate with ignition

The Remote function cannot operate with ignition

Automatic - Arm OFF

External Light turns for 3 minutes

Automatic - Arm

External Light turns for 5 minutes

Three Chirps/LED Three pulses = External Light turns for

Four Chirps/LED Four pulses = External Light turns for minutes.

Five Chirps/LED Five pulses = External Light turns for

T o exit Programming Mode, turn the Ignition the "Of position, simply wait for seconds. The horn will respond with a short + long beep and the LED turns f confirm exit.