OPERA TION T ransmitter Operations

The door transmitter has four buttons (labeled LOCK, UNLOCK, AUX and HORN) control operation the system. When any the buttons pressed, a coded Ultra - high frequency (UHF) radio signal transmitted the receiver the vehicle.

The transmitter must within approximately meters (33 feet) the vehicle for the receiver detect the coded The Remote Keyless Entry system has fect the normal operation the power door

When the LOCK button pressed, the doors will lock and the lights will flash once indicating that the doors are locked. The dome light will for 5 seconds upon locking the door remote. For audible confirmation the door lock, press the LOCK button a second time and the horn will beep once confirm the doors are locked.

When the UNLOCK button pressed once, the drivers door will unlock and the lights will flash twice indicating that the door unlocked. The dome light will for seconds upon unlocking the door remote. Pushing the UNLOCK button a second time within 3 seconds will unlock both doors.

Note: AUT O - ARM feature selected, the keyless entry system will automatically - arm itself seconds after the doors are unlocked with remote transmitter . Automatic - arm will cancel any door opened before the seconds timer has

Press and hold the AUX button the transmitter for second turn perimeter trailer access lights "Of (if

Press and hold the HORN button the transmitter for 3 seconds. The horn will immediately sound and running lights will flash. During panic mode, the normal function this transmitter button will suspended. LOCK and UNLOCK buttons cannot used lock and unlock the doors. T o stop the alarm, press and hold the HORN button the transmitter again for 3 seconds. the button not pressed, the alarm will automatically stop after seconds.

Battery Replacement

Under normal use, the transmitter battery should last approximately two When battery replacement becomes necessary , use a Panasonic 3 type Replace the battery follows:

Open the transmitter inserting a dime between the two halves the transmitter case (near the key ring hole) and twisting.

Remove the battery

Install a new battery with the positive (+) side down.

Battery , positive (+) side down

Align the transmitter case then snap the case together

Check the operation the transmitter .