INSTRUMENTS AND CONTROLS

Note: When ABS malfunction detected, anti - lock braking the fected wheel(s) will disabled and normal braking will return; the other wheels will retain anti - lock braking. Operate the vehicle normally and have the ABS system serviced correct the

23. Power T ake - Off Operating Indicator (Green) – Indicates O

24. Cruise Control Indicator (Green) – Indicates that cruise control engaged.

25. Right T urn Signal Indicator (Green) – Flashes green when turn signal

26. Bendix Adaptive Cruise Control (ACC) Indicator (Red) –Illuminates when the Bendix ACC engages.

27. Reverse Indicator (Amber) – Indicates that the transmission Reverse.

28. Automatic T raction Control TC) Indicator (Amber) – Indicates that A operating and will flash when deep mud and snow

29. Neutral Indicator (Amber) – Indicates that the transmission Neutral.

30. Fasten Seat Belt W arning Indicator (If Equipped) (Red)

31.HEST Indicator (Amber) (If Equipped) – The High Exhaust T emperature (HEST) indicator displayed when the exhaust temperature reaches 300°C (572°F) and the regeneration process begins. When the regeneration process completed, the engine should allowed run until the HEST indicator shuts

During automatic regeneration while the vehicle moving, the HEST indicator will only illuminate during regeneration when vehicle speed less than 8 kph mph).

During a parked the HEST indicator will turn f when regeneration complete and the exhaust temperature has returned a normal

HEST Indicator

32. Fuel Gauge – Registers the fuel level the supply

Instruments And Controls

33. Mode Button (Basic Display Only) – This push button located directly below the Basic Display The push button used access, view and change information available the Basic Display Simply press and hold the push button for a moment navigate through the A long press the push button used clear trip data inactive fault

For more information this button, please refer the V - MAC® Operator ’ s Guide, TS898.

34. Speedometer Indicates road speed miles and/or kilometers per hour .

35. T achometer – Indicates engine speed revolutions per minute T achometer readings should used a guide for well prevent engine damage due

36. Air Application Gauge (If Equipped) – Indicates the air pressure being delivered the service brake chambers the tractor (and trailer , equipped);

Air Suspension Gauge (If Equipped) – Indicates the air pressure being delivered the air suspension system (100 psi

37. Hand - Control Brake Lever – Pull down activate the trailer brakes, the rear axle brakes the case a platform truck.

W Arning

The hand - contr brake system must NOT used for parking. NOT use apply service brakes while vehicle motion. not leave the vehicle while hand - contr brake applied.

38. Front Rear Axle and 39. Rear Rear Axle Oil T emperature Gauges (If Equipped) – Indicate rear axle oil temperature.

Caution

The maximum safe oil temperatur e for MACK r ear axles 121°C (250°F). Continued operation with oil above this temperatur e will cause rapid deterioration the s lubricating operties and NOT r Consult the vendor manual for non - MACK