Control, operation

Adjust the flow Super Finish settings, if necessary (see chapter "Operator’s menu", SF-Flow menu).

3.4.18Attachments in continuous operation (optional equipment)

This function allows for the operation of an attachment (e.g. mower rake). The function must first be activated.

Fig. 3-80 Operating elements for continuous mode operation

Preselecting continuous operation:

The continuous mode is preselected with the switch S124.

The working tool must be activated (S241), and servo control (S35) must be switched on.

Press the switch S124.

The indicator light in the switch is on. Continuous mode is now preselected.

Switching attachment on/off:

Continuous mode is activated/deactivated at the left joystick.

Press the rocker switch S451 down. The indicator light H329 is on. The attachment is switched on (in continuous mode).

Press the rocker switch S451 down. The indicator light H329 is off. The attachment is switched off.

Continuous operating mode is also switched off in the following cases:

–Servo control S35 is switched off.

–The safety lever is moved up.

–The working tool is deactivated (switch S241 off).

–The ignition is switched off.

Deactivating continuous mode:

To terminate continuous mode operation, press the switch S124 The indicator light in the switch is off.

Y268 on/off

Use this menu to activate the pedals for boom adjustment while an attachment (e.g. mower rake) is operated.

Setting values:

For a description, see chapter "Operator's menu", submenu "Y268 on/off".

Modified operation of Super Finish (optional equipment)

With the Super Finish function, the movement of the attachment can be slowed down, so that tasks can be carried out with greater precision. This is achieved by a flow reduction, which slows down the movement of the machine proportionally.

Press the switch S382 down.

Super Finish is activated. The Super Finish (SF) indicator light is on.

Operate the attachment and check the working speed.

Press the switch S382 up. Super Finish is deactivated. The Super Finish (SF) indicator light is off. Adjust the flow reduction settings, if necessary (see chapter "Operator's menu", SFFlow menu).

3.4.19Stick cylinder shut-down function (optional equipment)

3.4.19.1Operating principle

When the boom is moved, it can reach great heights and outreaches. The stick with attached load might collide with the operator's cab or impact on other objects. There is even a risk of collision with the operator's cab or the object, which would likely result in injury to the operator, and damage to equipment or the attached load. In order to assist the machine operator, the range of movement of the stick is limited by the electronic stick cylinder shut-down function.

This means that the stick can only be moved within a preset angle range (defined by a minimum and a maximum angle). The reach of the attachment thus depends on the stick cylinder shut-off point and the angle of the boom.

3.4.19.2Use of stick cylinder shut-down function

If the stick is to be moved beyond the shut-off point, the stick shut-down function can be overridden.

If the machine is to be operated with movement limitation, the stick cylinder shutdown must be set to the maximum values.

The stick cylinder shut-down function –is always activated during operation